DISPLAY
If a Telltale is Lit
Telltales alert you to possible system problems that could
represent a safety concern. If any telltales remain lit after
starting the FUV, try restarting the FUV:
1. Set the Direction switch to Neutral (•).
2. Turn the Key switch to the Off position.
3. Wait 30 seconds, then turn the Key Switch to On,
and press the Start button on the left grip.
If the telltale still remains lit, it could be an indication of a
problem and/or a safety issue. Contact Arcimoto
Technical Support at (541) 780- 0032 before driving
again.
Drive Screen - Touch Buttons
The Drive Screen features two touch buttons: OFF and
CONFIG, both at the top of the Display:
Press to turn the FUV Off.
Press to access the Set PIN screen, to
change the PIN for your FUV.
Turning the FUV OFF (via the Display)
Press the OFF button on the Display to turn the FUV OFF.
This is the same as turning off the Key Switch.
Changing the PIN On Your FUV
Each FUV is assigned a unique 6-digit PIN at the factory.
You can change this PIN via the Configuration screen.
For instructions, refer to page 79.
FUV Owner's Guide - 53
To Next Page
Loading...
