PRE-RIDE INSPECTION
Pre-Ride Inspection
To help keep your FUV in safe operating condition, always
perform these pre-ride inspections before each use. This
is especially important before making a long trip and
when removing the vehicle from storage.
If you find anything that needs adjustment, replacement
or repair, contact Arcimoto Technical Support at (541)
780-0032 for service.
Failure to perform recommended pre-ride inspections
could lead to a reduced level of safety.
You must be familiar with all instruments and controls to
perform the pre-ride inspections. See the Controls section
on page27.
Turn the ignition key to the ON position to perform
electrical pre-ride inspections. Return the ignition key to
the OFF position after completing these inspections.
If inspection of any electrical item reveals component
failure, repair or replace the component before operating
the vehicle.
Electrical
Charge Level
Check the Battery Charge Level
Indicator (on the Display) for an
adequate charge Level. Charge as
needed.
Front Lights
Turn the ignition key on. Verify that the
headlights and auxiliary lights (if
equipped) illuminate.
Switch to high beam. Verify that the
high beam indicator comes on and that
headlamp brightness increases.
FUV Owner's Guide - 75
To Next Page
Loading...
