SEAT BELTS
Verify a Proper Fit
To work properly, the seat belts rely on a proper fit. A
slack seat belt greatly reduces occupant protection. Once
both seat belts are clipped in, make sure that both belts
are snug.
With your feet flat on the floorboards, and your back
against the backrest, the shoulder straps should cross
right in the center of your chest, and the lap belt should fit
snugly across your hips.
Make sure you can easily reach the Foot Brake Pedal and
that your arms are slightly bent when holding the
handlebars. Your chest should be at least 10 inches (25
cm) from the center of the handlebars.
Releasing the Seat Belts
To release the seat belts, press the square red button at
the center of the each buckle, on each side of the seat.
Hold the belt near the buckle to prevent the belt from
retracting too quickly, then press the button on the
buckle. The belt retracts automatically.
Ensure there is no obstruction that prevents the belt from
fully retracting.
The seat belts should not hang loose. If a seat belt does
not fully retract, contact Arcimoto Technical Support at
(541) 780-0032 for service.
FUV Owner's Guide - 59
To Next Page
Loading...
