FUV Owner's Guide - 60
Inspecting the Seat Belts
Inspect all seat belts for proper operation before each use.
1. Push the latch plate into the buckle until it clicks.
The latch plate must slide smoothly into the buckle.
A click indicates that it’s securely latched.
2. Push the red button at the center of the buckle to
make sure it releases freely.
3. Pull each seat belt completely out and inspect the
full length for any damage, including cuts, wear,
fraying or stiffness.
If any damage is found, or if the seat belt does not
operate properly, have the seat belt system
checked and/or replaced by your authorized dealer
or another qualified person.
Cleaning the Seat Belts
To clean dirt or debris from the seat belts, sponge the
straps with mild soap and water.
Do not allow water, cleaners, or fabric to enter a seat
belt mechanism. If you notice any damage on a seat belt,
contact Arcimoto Technical Support at (541) 780-0032
for assistance.
l Do not use bleach, dye or household detergents.
l Do not let wet seat belts dry in the sun. Move the
FUVto a shaded area until the belts are totally dry.
l Make sure that seat belts are totally dry before
allowing them to retract.
SEAT BELTS
To Next Page
Loading...
