SBC-GX1 Windows XP Embedded Quickstart Introduction
Handling your board safely
Anti-static handling
The boards in this Development Kit contain CMOS devices. These could be damaged in
the event of static electricity being discharged through them. Please observe anti-static
precautions at all times when handling circuit boards. This includes storing boards in
appropriate anti-static packaging and wearing a wrist strap when handling them.
Battery
The board contains a Lithium non-rechargeable battery. Do not short-circuit the battery
or place it on a metal surface where the battery terminals could be shorted. During
shipment, the battery is isolated from the board’s circuitry. It should be connected
before using the board. For details, refer to the Jumper and Connections section of the
SBC-GX1 Technical Manual.
If the battery needs to be replaced, please ensure that the new part conforms to the
same specification.
Packaging
Should a board need to be returned to Arcom, please ensure that it is adequately
packed, preferably in the original packing material.
Electromagnetic Compatibility (EMC)
The SBC-GX1 is classified as a component with regard to the European Community
EMC regulations. It is the user’s responsibility to ensure that systems using the board
comply with the appropriate EMC standards.
© 2004 Arcom Issue D 7
To Next Page
Loading...
Need help?
General
