Pxxxx/EN SS/C11
Safety Section Page 9/10
8. COMPLIANCE MARKING FOR APPLICABLE EUROPEAN DIRECTIVES
The following European directives may be applicable to the equipment, if so it will carry the
relevant marking(s) shown below:
Marking
Compliance with all relevant European
Community directives:
Product safety:
Low Voltage Directive - 73/23/EEC
amended by 93/68/EEC
EN 60255-5: 2001
Relevant clauses of
EN 61010-1: 2001
EN 60950-1: 2001
EN 60664-1: 2003.
Compliance demonstrated by reference to safety
standards.
Electromagnetic Compatibility Directive
(EMC) 89/336/EEC amended by
93/68/EEC.
The following Product Specific Standard
was used to establish conformity:
EN 50263 : 2000
Compliance demonstrated via the Technical
Construction File route.
Where applicable :
II (2) G
ATEX Potentially Explosive
Atmospheres directive 94/9/EC,
for equipment.
The equipment is compliant with Article 1(2) of European
directive 94/9/EC. It is approved for operation outside an
ATEX hazardous area. It is however approved for
connection to Increased Safety, “Ex e”, motors with rated
ATEX protection, Equipment Category 2, to ensure their
safe operation in gas Zones 1 and 2 hazardous areas.
CAUTION – Equipment with this marking is not itself
suitable for operation within a potentially explosive
atmosphere.
Compliance demonstrated by Notified Body certificates of
compliance.
Radio and Telecommunications
Terminal Equipment (R & TTE)
directive 95/5/EC.
Compliance demonstrated by compliance to the Low
Voltage Directive, 73/23/EEC amended by 93/68/EEC,
down to zero volts, by reference to safety standards.
To Next Page
