Arjo Tornado - Configuration; Test and Verification

23
5. Connect the printer cable:
• Connect one end to the interface cable (E).
• Attach the cable bracket (6001003001) to the metal
under the opening in the top panel (F), and attach the
printer cable.
6. Replace the top panel.
7. Position the printer (G) in a suitable position, connect the
power to the printer, and turn it on.
8. Connect the machine to the power.
3.1.2 Conguration
The printer is factory congurated and no additional installations
need to be done. Where necessary, see the “Technical manual” for
information regarding standard settings.
3.1.3 Test and verication
When the machine is turned on it recognizes the printer which
starts to print.
To verify the installation, perform a dummy run and check that
the printout looks good. How the printout can look is shown in the
“User manual”.