ASCOM d41 User Manual

TD 92582GB
2009-12-15/ Ver. C
User Manual
Ascom d41 DECT Handset
48
The easy replacement procedure is done via the handset display and the DC4 Advanced
Desktop Charger, or the CR3 Rack Charger.
The following settings are replaced during easy replacement:
• DECT registration
• User parameters (including User ID)
• Contacts
• The extension number is assigned to the new handset.
The following settings are not replaced during the easy replacement:
• Call list
•License
1
14.4.1 Before Starting Easy Replacement Procedure
1 Check that both the old handset (that is, the handset to be replaced) and the new
handset (that is, the replacement handset) are of the same device type (d41).
Note: It is possible to perform Easy Replacement between different product licenses (that
is; Basic and Advanced). The new handset’s product license is not replaced by the old
handset’s variant license during the procedure
1
.
2 Check that the software of d41 is of version 2.8.x or greater, by enter *#34# in idle
mode.
3 Check that the software of CR3 Rack Charger or DC4 Advanced Desktop Charger is
of version 1.3.x or greater by using the PDM. See Configuration Manual, Ascom
d41 DECT Handset, TD 92641GB .
4 Make sure that the handset batteries are charged before starting the easy
replacement procedure.
5 Switch off the new handset by long pressing .
14.4.2 Easy Replacement Procedure
During the Easy Replacement procedure, the LEDs of the handset and the charger follow
the same LED indications. This means that if the old handset has a broken display, the LED
indications on the charger and on the handset can be used to follow the replacement
procedure. Before and after easy replacement, the LEDs may have different LED
indications. For more details, see also LED Indications during Easy Replacement on page
50.
IMPORTANT: Never remove a handset from the charger until the instructions in the
display or the LED tells you to do so (see status on the LED if the display is
broken). If there is an error indication, it may be allowed to remove the
handset, see 12 Troubleshooting on page 42 for further instructions.
After the old handset has been in the charger, the new handset needs to
be placed in the charger regardless if the replacement was successful or
not. Failing to do so may result in malfunction and the new handset will
need to be sent for service.
1. A handset’s product license, for example d41 Basic, can be moved to another handset using PDM/IMS2.

ASCOM d41 Specifications

General

Type	DECT telephone
Answering machine	No
Mounting type	-
Product color	Gray
Speakerphone	Yes
Phonebook capacity	500 entries
Languages support	CZE, DAN, DEU, DUT, ENG, ESP, FIN, FRE, GRE, HUN, ITA, NOR, POL, POR, RUS, SLK, SWE, TUR
Standby time	180 h
Battery recharge time	4 h
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Number of handsets included	1

Weight and Dimensions

Depth	24 mm
Width	53 mm
Height	133 mm