5200 Series Programming Instructions
8
80-9352-0022-020 Rev 2 06/23
Copyright © 2023, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or in
part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
Figure 21
D. Adjust the Operator Settings.
Select the Settings application page to adjust the operator’s settings. Click on each tab to access settings for
Speed/Force, Timing/Location, additional Options, and Save/Restore.
For options that have a value range, a slider will be
displayed allowing the desired range to be selected, as
shown in Figure 21.
For options that have a selectable setting, such as On
or Off, buttons will be displayed, as shown in Figure 22.
Click on the setting to adjust the value. After an
adjustment has been made, click Save to set the new
setting or Cancel to revert to the operator’s current
setting.
C. Set the door open and closed positions.
To set the door open and closed positions for the
operator, select the Setup application page (Figure 19)
and perform the following steps.
1. Select the operator’s mode by moving the toggle
switch of the PUSH/PULL setup button (located on
the operator control board) to the left for PUSH or
right for PULL.
(Refer to “Select the arm mode:” on page 4)
2. Manually close the door and select
“Set Closed Position”.
3. Open the door to the fully open position. While
holding door open, select “Set Open Position”.
NOTE: If there is a wall or door stop at the fully
open position, hold the door slightly away from
wall or stop.
4. Close the door completely and select “Learn” to
start the Learn process.
NOTES:
‒ The monitor board is preset for typical
applications. If a red LED is illuminated on the
monitor board after the Learn Cycle has been
completed, contact Technical Product Support
for assistance.
‒ Door will automatically move through an opening cycle.
Be sure there are no obstructions.
Figure 19 Figure 20
Check
Setup Using Wi-Fi (cont.):
Figure 22
Once the steps have been completed, refresh the browser page to confirm all steps have a
✓✓
, indicating setup has
been successful. (Figure 20)
To Next Page
Loading...
