ATAGO PRM-100a - Connecting Detection and Display Sections; DS-2 Cable Connection Procedure

17
7. Connecting the Detection Section to the Display Section
 WARNING
◇Turn the power switch of the display section to OFF and unplug it from the
AC outlet prior to attaching or detaching the DS-2 cable to or from the
terminal.
m Remove the socket caps from the display section to access the terminals (Fig. 7-1).
After mounting the detection section on the piping, connect it to the display section with the DS-2 cable
(included) (Fig. 7-2).
Fig. 7-1