ATAGO PRM-100a - Configuring Recorder Output Settings

29
(3) Setting recorder output
① Press the START/STOP key to pause the
measurement.
②Press the SCALE key three times.
The SET UP light will then blink, and "SEt" will be
displayed on the measurement value display.
③Press the ENTER key and the SET UP light comes
on.
Using the ↑ ↓ keys, select "3. rEC" (Fig. 11-10).
④Press the ENTER key to enter the Recorder output
setting screen.
Fig. 11-10
⑤ The temperature display will indicate "Lo" (Fig.
11-11), and the screen for setting the recorder
output lower limit will appear.
Use the arrow keys to change the value.
※Press the SCALE key to return to the previous
"3. rEC" screen.
Fig. 11-11
⑥To confirm the changes, press ENTER.
The temperature display will indicate "Hi" (Fig.
11-12), and the screen for setting the recorder
output upper limit will appear.
Use the arrow keys to change the value.
※Press the SCALE key to cancel the changes and
return to the "3. rEC" screen.
⑦Press the ENTER key to confirm the changes.
The display will return to "3. rEC".
Fig. 11-12