ATAGO PRM-100a User Manual

24
(3) Change from Brix Mode to nD
①During measurement, the READING light blinks,
and the display will show Brix (%) readings (Fig.
10-4).
By pressing the START/STOP key, the READING
light will turn off, and "StoP" will display, ceasing
measurement (Fig. 10-2).
The "Brix (%)" light will remain illuminated.
②Press SCALE until the "nD" light blinks, indicating
refractive index mode is selected.
Fig. 10-4
③Press ENTER to confirm this selection.
The "nD" light will remain illuminated.
④Press START/STOP to resume measurement.
The READING light will blink and measurements
will be displayed as nD values (Fig. 10-5).
Fig. 10-5
(4) Change from Brix Mode to Conc
①During measurement, the READING light blinks,
and the display will show Brix (%) readings (Fig.
10-4).
By pressing the START/STOP key, the READING
light will turn off, and "StoP" will display, ceasing
measurement (Fig. 10-2).
The "Brix (%)" light will remain illuminated.
②Press SCALE twice and the "Conc" light blinks,
indicating Conc1 mode is selected. After “Conc1” is
displayed, the last value will be displayed.
③Press ENTER to confirm this selection.
The "Conc" light will remain illuminated.
↓ 0.5sec
④Press START/STOP to resume measurement.
The READING light will blink, and measurements
will be displayed as Conc1 values (Fig. 10-6).
In case of a concentration scale (Conc) not
programmed, "- - - -" will display.
Fig. 10-6
Conc1

ATAGO PRM-100a Specifications

General

Brand	ATAGO
Model	PRM-100a
Category	Measuring Instruments
Language	English