ATAGO PRM-100a - Powering On the Instrument; Safety Checks Before Power On; Powering On Procedure

22
9. Turning On the Power
 WARNING
◇This instrument is designed to plug into outlets providing alternating
current between 100V and 240V.
Voltages outside of this range may increase the likelihood of short
circuiting, smoking, or fire.
◇Do not use power cables that are damaged, broken or modified.
Use of such cables may increase the likelihood of fire, electrical shock or
burns.
Contact ATAGO or an authorized ATAGO distributor for repair or
replacement cables.
 CAUTION
◇Do not handle plugs with wet hands.
◇When disconnecting the power cable from an AC outlet, hold it by the
plug; pulling the cable could damage it, increasing the likelihood of fire or
electric shock.
◇When plugging the power cable to an AC outlet, ensure that the ground
pin is connected as well.
①Make sure that the DS-2 cable is functioning properly.
②Ensure each output cable (recorder, RS-232C, alarm) is wired and plugged in correctly.
③Plug the AC power cable of the display section into a 100V to 240V AC outlet and turn the power switch
to the ON position.
Measurement will begin a few seconds later.