1
CONTENTS
1. Precautions for Use ··································································································· 2
2. Refractive Index and Brix(%) ····················································································· 7
(1)What is refractometer? ················································································································ 7
(2)What is the Refractive Index? ····································································································· 7
(3)Brix(%) scale ······························································································································· 7
(4)Temperature correction ··············································································································· 7
3. Unpacking and Installation ························································································ 8
(1) Unpacking ··································································································································· 8
(2)Installation ···································································································································· 8
4. Names and Functions of Components ······································································ 9
(1)Detection Section (Fig. 4-1 and Fig. 4-2) ···················································································· 9
(2)Display Section ·························································································································· 10
5. Mounting the Detection Section ··············································································12
(1)Types of Sample Inlet Unit (Fig. 5-1) ························································································ 12
(2)Mounting the Sample Inlet Unit (Fig. 5-2) ················································································· 13
(3) Mounting on the Piping (main) (in the case of L type) ····························································· 14
(4) Mounting on the Piping (main) (in the case of straight type) ··················································· 14
(5) Position of the thermo sensor ·································································································· 14
6. Mounting the Display Section ··················································································15
7. Connecting the Detection Section to the Display Section ·······································17
8. External Output ·······································································································19
(1)Recorder Output (Fig. 8-2 and Fig. 8-3) ··················································································· 19
(2)RS-232C Output ························································································································ 20
(3) Alarm Output (high- and low-limiter output) ············································································· 21
9. Turning On the Power ·····························································································22
10. Setting Measurement Value Display Modes····························································23
(1) Common Operation ·················································································································· 23
(2) Change from nD Mode to Brix ································································································· 23
(3) Change from Brix Mode to nD ································································································· 24
(4) Change from Brix Mode to Conc ····························································································· 24
(5) Confirmation of Measurement Values at Each Mode ····························································· 25
11. Setting Measurement SET UP Mode ······································································26
(1) Calibration Procedure··············································································································· 26
(2) Setting alarms ··························································································································· 28
(3) Setting recorder output ············································································································· 29
(4) Setting Conc (User Scale) ········································································································ 30
(5) Setting Decimal Place ·············································································································· 44
(6) Scale ON/OFF Set-Up ············································································································· 45
12. Measurement Procedure ·························································································47
13. Cleaning the Prism ··································································································48
14. Definitions of Error Messages ·················································································49
15. Availability of Parts ··································································································50
16. Specifications ··········································································································51
17. Dimensions ··············································································································52
18. Repair Service and Warranty Period ·······································································53
19. ATAGO CO.,LTD. Service Centers ··········································································54
To Next Page
Loading...
Need help?
General
