ATAGO PRM-100a - Scale ON;OFF Setup

45
(6) Scale ON/OFF Set-Up
This setting is for displaying only the particular scale(s) used on a regular basis.
For example, to display only "Brix" and "Conc1 (concentration)" : select "ON" for the 2 aforementioned scales
and "OFF" for all other scales.
Press the SCALE key again to display only "Brix," "Conc1 (concentration)" and "Set."
① Press the START/STOP key to pause the
measurement.
② Press the SCALE key .
The SET UP light will then blink, and "SEt" will be displayed
on the measurement value display (Fig. 11-1).
③ Press the ENTER key and the SET UP light comes
on.Using the ↑ ↓ keys, select "6. CH" (Fig.11-30).
④ Press the ENTER key to display the nD ON OFF
setting screen.
The nD LED will light up.
Use the ↑ ↓ keys to select ON or OFF (ON: nD will be
displayed on the measurement results display screen, OFF:
results will not be displayed)（
↑ ↓ keys
Fig.11-31）.
Press the ENTER key to confirm the selection.
Fig.11-30
↑ ↓ keys
Fig.11-31
※Press the SCALE key to cancel setting procedures.
On
●
6. CH
OFF
●