AT&T UNIX - Page 223

Using Printers
6 When you have entered the appropriate serial,
parallel, and remote printer information,
point to the Default Printer Type: field,
which specifies the default printer to be one
of the printer types previously set up. For
example, if you enter Serial in this field,
the Print command sends your files to the
printer displayed in the Serial: Port 0
field, unless specified otherwise in the
Print form.
You must enter a printer type in this field,
even if you have only one printer set up.
7 Press <Cmd> to display the default printer
selections.
8 Point to the type of printer you want to make
your default printer.
9 Press <Enter>.
The selected printer type is displayed in the
Default Printer Type: field.
Note
If, at a later date, you change the
default printer, be sure the new default
printer is properly set up.
10 Press <Enter>.
If a message tells you to reenter the printer
name, you have set up more than one field
with the same printer name. Change one of
the field names and then press <Enter>.
A warning message reminds you that all
current printing is temporarily halted until
this setup procedure is complete.
11 Press <Enter>.
3-137