AT&T UNIX - Page 224

Using Printers
Serial Printer Setup
Use the following procedures to fill in the Serial:
field in the Printer Setup form:
3-138
1 Point to the field for the serial port number
to which you want the printer attached. For
example, if you want to set up a serial
printer on the RS-232 expansion port 3, point
to the Serial: Port 3 field.
The Port 0 field corresponds to the built-in
RS-232 port on your UNIX PC. The Port 1
through Port 6 fields correspond to the RS-
232 expansion ports; if you use one of these
ports, make sure you have an RS-232 expansion
board installed at that port. To determine
which port number you should use, refer to
"Setting Up Expansion Ports" in the "Setting
Up the UNIX PC" chapter in the Managing the
UNIX PC section of this guide.
2 Press <Cmd> to display the available serial
printer names.
3 Point to the name of the serial printer you
want to set up and press <Enter>.
If the name of the printer you want to set up
is not displayed, point to I Other I and press
<Enter>.
The name of the serial printer you selected
appears in the Serial: Name field for the RS-
232 port you selected.
Note
If you configure a serial printer and
the RS-232 port you chose is currently
configured for some other device, a
confirm message appears to remind you
that you are removing the current setup.
Press the Enter key to continue setting
up the port, or press the Cancl key to
leave the port set up as it is.