AT&T UNIX - Page 249

Setting Up the UNIX PC
The following list explains the device types:
NONE Default entry that appears if
nothing is set up on the RS-232
port. NONE is also used to remove
a configured device.
MODEM Connects an external modem to the
RS-232 port.
TERMINAL Connects a terminal to the RS-232
port.
COMPUTER Connects another computer to the RS-
232 port.
OTHER Connects another device, such as a
plotter, to the RS-232 port.
Note
Use the Printer Setup selection in the
Hardware menu to configure a serial
printer on the RS-232 port.
8 Point to the desired device type.
9 Press <Enter>.
10 Press <Return>.
The highlight moves to the Device Speed:
field. The correct device speed entry
depends on the device type you are
connecting. See the device instruction
manual for more information.
11 Press <Mark> until the correct baud rate
(line speed) appears.
12 Press <Enter>.
4-13