AT&T UNIX - Page 250

Setting Up the UNIX PC
4-14
13 If you are configuring a terminal, an
information message tells you the RS-232 port
is set up. Press <Enter> to continue
working.
If you are configuring a modem, go to step
14. If you are configuring a computer, go to
step 15. If you are using the Other
selection, go to step 16.
14 If you are connecting a modem, the Connect to
Modem form requests the name of the modem, as
shown below:
III·
Connect to Modell
Modem Name:
o Press <Mark> until you see the type of
modem you want to use, and then press
<Enter>.
An information message tells you the RS-
232 port is set up.
o Press <Enter> to continue working.
15 If you are connecting a computer, a form
requesting the type of calls appears. If you
are receiving calls only, select HOST only.
If you are making but not receiving calls,
select CALLER only.