AT&T UNIX - Page 251

Setting up the UNIX PC
Caution
The UNIX PC RS-232 port cannot be
configured as both a host and a caller
at the same time. When two computers
are connected, one must be designated as
the "caller" and the other as the
"host." Connecting two host computers
via the RS-232 ports causes erratic
behavior on both machines.
o Press <Mark> until you see the appropriate
entry.
o Press <Enter>.
An information message tells you the RS-
232 port is set up.
o Press <Enter> to continue working.
16 If you are using the Other selection to
configure a special device, a form requesting
the device name and type of connection
appears. In most cases, you will select
CALLER only if the device receives output
only from the UNIX PC. Refer to the manual
for the device you are configuring for more
information.
Setting Up ExPansion Ports
When you install expansion boards containing RS-232
ports and the accompanying RS-232 Expansion software, a
new selection is added to the Hardware Setup menu.
This new selection is RS-232 Expansion Setup. You must
use this selection and choose the expansion port number
to be configured before configuring the expansion port.
To set up an expansion port:
1 Point to I Administration I in the Office of
install.
2 Press <Enter>.
You see the Administration menu.