- 51 -
4. DETECTION
The detection LED and the audio pulse once every 10
seconds when the control module detects a problem in
the detection circuit. Please check the integrity of the
detection wire.
5. RELEASE
The release LED and the audio pulse once every 10
seconds when the control module detects a problem in
the release circuit. Please check the connection with
the automatic actuator.
5.3.3.2 Buttons
6. DELAY
This button is used during programming and can be
used for maintenance checks.
7. RESET
Pressing this button for more than 1 second will reset
the controller after a fault detection or activates the
system after restoring power e.g. after replacing the
internal battery.
5.3.4 Daily check
The LED’s status on the ANSUL control module
should be checked daily prior to starting up the
compressor. The green Power LED (1) should flash
every three seconds, no other LED may flash and no
audio alarm should be sounding! It is not allowed to
start up the compressor when there are any deviations.
To Next Page
Loading...
Need help?
General
