the battery slot (f) to provide power in the same way you would attach a power source to
your NINJA V+.
Connecting a power source to the ATOMOS CONNECT supplies power for
both NINJA V+ and CONNECT.
The first time you power on your NINJA V+ with
ATOMOS CONNECT attached, you will be prompted to select your region of
use. Tap Region to cycle through the options and then tap on Confirm. This
message will also appear after performing a factory reset and after
installing new AtomOS firmware.
To attach an NP-F / L-Series type battery to ATOMOS CONNECT
l
Place the battery in front of the retaining lug, align with the connectors and slide the
battery into the battery slot (f) until it clicks into place
To Next Page
Loading...
