Input via Atomos CONNECT
With the ATOMOS CONNECT attached, you will be able to tap on Input in the Input Menu
to switch to SDI as your input. The Source Menu will open, where you can select SDI. A
note will advise that changing input source will take a few seconds. Tap Ok and wait for
your device to switch to SDI source mode. Once in this mode, the input menu will
resemble the image shown above.
The ATOMOS CONNECT features a connector for 12G SDI input, which allows you to mon-
itor and record SDI video up to 4Kp60 from a range of professional cameras and video
sources.
To use the ATOMOS CONNECT with your NINJA V+, firmware version 10.8
or later needs to be installed. To use SDI RAW, firmware version 10.6 or
later needs to be installed.
To use the SDI RAW feature with ATOMOS CONNECT you will need to activate this fea-
ture. Refer to the "Activation Menu" on page 225 section for more information.
Compatibility Mode (SDI)
Where SDI has been selected as your input, a Compatibility Mode toggle switch will be vis-
ible under Source. This mode improves the signal locking process over SDI, when working
To Next Page
Loading...
Need help?
General
