Name: Atomos NINJA V+
Brand: Atomos
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Input via AtomX SDI Expansion Module

The AtomX SDI expansion module adds 12G SDI I/O to your NINJA V+ with 2 x industry

standard full size BNC connectors. When you have an AtomX SDI module attached to your

NINJA V+, you will be able to tap on Input to switch to SDI as your input. You will then be

prompted to reboot your NINJA V+ so that it can to change to the SDI input. Tap Confirm

and wait for your device to reboot in SDI source mode.

Once in this mode, the input menu will resemble the image shown above. The AtomX SDI

Module does not need to be activated before use, however to use the SDI RAW feature

you will need to activate this feature. Refer to the "Activation Menu" on page 225 section

for more info.

You can only switch from HDMI input to SDI input when the AtomX SDI

Expansion Module or ATOMOS CONNECT is connected to your NINJA V+.

To use the AtomX SDI Module with your NINJA V+, or the SDI RAW feature,

firmware version 10.65 or later needs to be installed.

Other manuals for Atomos NINJA V+

Questions and Answers:

Need help?

Do you have a question about the Atomos NINJA V+ and is the answer not in the manual?

General