AtomX Expansion Modules
AtomX expansion modules attach to the AtomXpansion port on your NINJA V+, and
provide additional connections and functionality.
AtomX SDI Expansion Module
The AtomX SDI Expansion Module (A) adds the quality and convenience of SDI con-
nectivity to your NINJA V+, which allows you to monitor and record SDI video up to
4Kp60 from a range of professional cameras and video sources. The two BNC connectors
(B) allow for input and output connections, so you can send video to or receive video from
any SDI device. This provides flexibility for any video or film production to allow all crew
including directors, cinematographers, assistants and focus pullers to monitor and replay
identical and calibrated content in HDR at the same time.
To use the AtomX SDI Module with your NINJA V+, firmware version 10.65
or later needs to be installed.
The AtomX SDI Expansion Module also allows you to cross convert signals between HDMI
and SDI. This means that where HDMI sources are connected to your NINJA V+, an SDI
signal can be output from both of the BNC connectors on your AtomX SDI Expansion Mod-
ule. Where an SDI video signal is connected to your AtomX SDI Expansion module, you
can output an HDMI signal over the HDMI Out connector on your NINJA V+. Cross con-
version happens automatically, and does not need to be enabled. For more information on
cross conversion refer to "Cross Conversion" on page 106.
To Next Page
Loading...
Need help?
General
