Inserting and Removing Media
Inserting Media
On the rear of the unit is a 2.5” slot designed for your media. To insert an AtomX
SSDmini, Master Disk Caddy II/III or the AtomX CFast adapter, gently push the media
into the slot until it stops at the end of the drive slot.
Removing Media
The SSDmini, Master Caddy II/III and the AtomX CFast adapter are all hot-swappable, so
you can remove the media at almost any time – even while the unit is turned on. But don’t
do it while recording or you will get a corrupted file that may be unplayable. To remove
media, simply pull it out from the slot by holding the top and bottom tabs on the media
itself.
The NINJA V+ disk slot does NOT have a release latch for media. It is a fric-
tion-fit system. Simply pull the SSDmini / Master Caddy II out using the top
and bottom tabs on the caddy itself.
The AtomX SSDmini Handle is available as an optional accessory, and can
be attached to your AtomX SSDmini. This allows it to be used with existing
ATOMOS Master Caddy II devices, and also reduces handling and potential
damage to the disk casing.
To Next Page
Loading...
