AtomX CAST
Select to use the features of the AtomX CAST. To be available for selection, the AtomX
CAST module needs to be connected to the NINJA V+ before powering it on.
When AtomX CAST is connected to your NINJA V+, the AtomX SDI option
will be greyed out since you cannot use the SDI module when the AtomX
CAST is attached.
RAW inputs are not supported when using the AtomX CAST for switching.
If you power on NINJA V+ after using the AtomX CAST mode, you may see
a warning notifying you that an AtomX CAST module has not been detected.
You will be advised to Power Off your NINJA V+ and attach the module, or
to change modes and operate without the module.
To Next Page
Loading...
