2. Calibration Port
The Calibration 2.5mm jack port beneath the power button allows for connection of
the optional x-rite i1 display pro unit.This single port is able to be used to calibrate
both devices and each channel will display as a separate option in the Atomos Cal-
ibration software. This software will be available via www.atomos.com/support
3. Headphone Ports
Both channels have an independent 3.5mm headphone jacks for monitoring audi-
o.The volume control is located in the Meters menu ā accessed by touching the Audio
Meters on the main screen, or via the Setting Menu.
4. Dual record
Pressing this button will trigger both units to start recording based on current set-
tings.To stop recording, press and hold until recording has stopped.
5. Disk slots
Insert compatible media. AtomX SSDmini may be used with the addition of SSDmini
handles. DO NOT use SSDmini media without the attached handle or disks may
become logged inside the unit.