TRIGGER
The SHOGUN STUDIO 2 can be remotely triggered to record from your camera. Select the
correct triggering option for your camera and set Trigger to ON.
Source
The SHOGUN STUDIO 2 can be remotely triggered to record from your camera. For HDMI
inputs, tap Source to cycle through the following trigger sources:
l
HDMI: If HDMI timecode is selected, you have the choice to start and stop recording
remotely from the source camera timecode.
l
None: Select to disable the record trigger.
l
Timecode: For older cameras or cameras that don’t have Start/Stop flags for trig-
gering recording, the rolling timecode trigger will trigger recording automatically on
the SHOGUN STUDIO 2 when it detects rolling timecode on the camera.
l
Camera Manufacturer: When you have an SDI signal connected to your SHOGUN
STUDIO 2, and have selected SDI at Input, you will be able to tap Source to cycle
through camera manufacturers as well as Timecode or None as the source of a trig-
ger.
Trigger (On/Off)
When you have selected a trigger source, you can enable or disable the trigger by tapping
the ON/OFF switch.
Note that where you have selected a camera manufacturer, you cannot dis-
able the trigger
DEVICE
Manufacturer: Displays the camera or device manufacturer.
Name: HDMI Devices will display an EDID Device name if the information is available
from the HDMI device connected. Not all cameras carry an EDID device name. For cam-
eras such as the Panasonic LUMIX GH5 this will display as ‘Unknown’.
To Next Page
Loading...
