AUDIO
In this menu you can set how the analog and digital audio channels are allocated to your
recording. Whilst in switcher mode you can record an embedded digital stereo pair for
each input, and also embed the analog input within each ISO recording as well as the Pro-
gram recording.
Analog Audio
The icons indicate the status of connected analog audio. If the icons are grey, analog
audio is not armed. To Arm them, tap Go to Audio to be taken to the audio menu.
In the audio menu, the first set of audio meters on the left are the analog audio channels.
Tap the L REC and R REC icons under the meters to toggle recording on and off for the left
and right channels of analog audio. When armed, the icons will be red, and black and
white when not armed for recording.
Once activated in the audio menu, your channel settings will be displayed under AUDIO
on the switching page as follows:
Both Red – Left and Right analog channels armed for recording.
L red – Only the Left channel is armed for recording.
R Red – Only the Right channel is armed for recording.
Arming the analog inputs will record the analog audio to each ISO recording
as well as the program recording. Analog audio will be located on tracks
1&2 with embedded digital audio moving to tracks 3&4. If you are not
intending to use the analog Audio inputs it’s best practice to turn them off.
Digital Audio Source
Under AUDIO, you can also choose the embedded digital audio track to record to the pro-
gram file. Tapping Digital Audio Source cycles between the options:
To Next Page
Loading...
Need help?
General
