HDMI Rolling Timecode Trigger Record
If the camera is in Record Run mode, recording can be stopped or started by a moving
Timecode via HDMI. When enabled the camera and the SHOGUN STUDIO 2 will start and
stop recording simultaneously.
Rolling Timecode trigger is for use in older cameras with TC only and no trig-
ger. If your camera is set to FREE RUN this trigger will start recording imme-
diately. Please be aware that not all cameras have Start/Stop flags for
triggering record, especially older cameras. In such cases rolling trigger in
REC RUN will need to be used to trigger recording automatically at the same
time as the camera starts recording.
HDMI Camera Trigger Record
The HDMI Camera trigger is available for supported cameras. There is a flag within the
digital signal that lets the SHOGUN STUDIO 2 know the start/stop record has been
pressed on the camera; in turn this will trigger the SHOGUN STUDIO 2 to start/stop
recording at the same time as the camera.
SDI Camera Trigger record
The SDI Camera trigger is manufacturer-specific, so you will need to select the appro-
priate manufacturer for your camera from the input menu. There is a flag within the
digital signal that lets the SHOGUN STUDIO 2 know that the start/stop record has been
To Next Page
Loading...
Need help?
General
