ATX TranScend - Page 85

SNMP ENTERPRISE ATTRIBUTES
TranScend Chassis – Operation Manual 8-3
::= { innoTransTranscendSystem 3 }
innoTransTranscendIpAddressType OBJECT-TYPE
SYNTAX InetAddressType
MAX-ACCESS read-only
STATUS current
DESCRIPTION
“The IP address type. Only ipv4(1) is expected.”
::= { innoTransTranscendSystem 4 }
innoTransTranscendHostAddress OBJECT-TYPE
SYNTAX InetAddress
MAX-ACCESS read-only
STATUS current
DESCRIPTION
“The address of the device.
This is primarily for easier logs when doing SNMP data collection
without and EMS/NMS.”
::= { innoTransTranscendSystem 5 }
innoTransTranscendTrapTarget1 OBJECT-TYPE
SYNTAX InetAddress
MAX-ACCESS read-write
STATUS current
DESCRIPTION
“The address to which traps shall be sent.
Syntax: ip-address-of-trap-destination”
::= { innoTransTranscendSystem 6 }
innoTransTranscendTrapTarget2 OBJECT-TYPE
SYNTAX InetAddress
MAX-ACCESS read-write
STATUS current
DESCRIPTION
“Secondary address to which traps shall be sent.
This is to support a secondary EMS/NMS.
Syntax: ip-address-of-trap-destination”
::= { innoTransTranscendSystem 7 }
innoTransTranscendDownloadImage OBJECT-TYPE
SYNTAX OCTET STRING (SIZE(0..99))
MAX-ACCESS read-write
STATUS current
DESCRIPTION
“Download image to the target system. The syntax of the parameters is:
download username password ftp-server-IP-address lename-includes-full-
path
If there is no parameters, the download status will be retrieved.”
::= { innoTransTranscendSystem 8 }
innoTransTranscendDownloadImageStatus OBJECT-TYPE
CHAPTER 8: