Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Caution
While pulling out the flange shaft (left-side), it must be held
centrally to avoid damaging the oil seal between the final drive
and the gearbox housing.
– Pull flange shaft -A- (left-side) out of gearbox, making sure that
shaft remains centered in opening at differential -arrow-.
– Remove torque converter.
– Extract ATF from torque converter ⇒ page 17 .
Caution
The self-locking centre differential can drop out of the gearbox
when the centre differential housing is removed.
– Loosen bolts -arrows- on housing for centre differential in di‐
agonal sequence and remove bolts.
– Slowly and carefully pull housing for centre differential off
gearbox.
– Pull self-locking centre differential -arrow- off input shaft.
– Take off shim -1-.
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
2. Dismantling and assembling planetary gearbox 23
To Next Page
Loading...
