Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– When installing retaining plate -2- in cylinder „A“ -item 1-, pay
attention to marks made on removal -arrows-
– Press retaining plate down using workshop press with assem‐
bly jig -T10277- .
– Renew circlip -1- and install new circlip with care.
– Make sure that circlip is seated securely in groove on cylinder
„A“.
– Release workshop press.
– Insert corrugated spring -2- into cylinder „A“ -item 1-.
– Fit outer plates -3- and friction plates -4- alternately.
– Insert last outer plate -5-.
– Insert circlip -6-.
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
80 Rep. gr.37 - Controls, housing
To Next Page
Loading...
