16
Short Fader (SF)
ASP8024-HE is an inline console. This means that
there are both input and monitoring signal paths
on the same channel. By default, the Short Fader
contains the input signal, however you can use the
channel flip switch to switch to the tape signal.
Don’t forget that you can assign the Aux/Cue Sends
and EQ to the Short Faders by pressing the SF buttons.
1 Copy LF selects the post fader LF signal as the input
to the Short Fader path, overriding the Mic or Tape
selection from the Flip Switch. This can be used to
ride the level of the Aux Sends on the Short Fader
(great for delay and reverb throws).
2 PAN places the signal in the stereo field by
balancing the signal between the left and right
channels.
3 MIX routes the SF signal to the stereo mix bus. It is
good practice to unroute any channels which are
not needed. This will reduce mix amp noise.
4 This is the SHORT FADER which controls the level
of the SF signal.
5 SOLO Mutes every channel except channels that
are soloed.
6 CUT will cut the Short Fader output of that particular
channel.
1
3
2
4
6
5
To Next Page
Loading...
Need help?
General
