Audient ASP8024 HERITAGE EDITION - Master Fader

25
Master Fader
1
2
3
The master fader is used to control the stereo
output of the console. Unlike the channel faders it is
calibrated with the 0dB mark at the top as the main
purpose of this fader is to create a fade out at the
end of a title.
The master fader is used to control the stereo
output of the console. Unlike the channel faders it is
calibrated with the 0dB mark at the top as the main
purpose of this fader is to create a fade out at the
end of a title.
Under normal operating conditions the fader should
always be set at maximum. If it has to be pulled
back a significant distance it indicates that the levels
to the mix bus are too high and should be reduced.
1 MASTER FADER. The Master Fadar is used to
control the stereo output of the console.
2 0dB MARK. Unlike the Long Faders, it is calibrated
with the 0dB mark at the main purpose of this
fadar is to create a fade at the end of a track.
Under normal operating conditions, the fader
should always be set at maximum.
3 -INF. With the fader here, the signal path is closed
and no signal will pass.