BroadCloud SIP Trunk
AudioCodes Mediant E-SBC 22 Document #: LTRT-12552
3. Click Start Software Upgrade; the Wizard starts, prompting you to load a .cmp file:
Figure 4-2: Software Upgrade Wizard - Load CMP File
Note:
At this stage, you can quit the Software Upgrade Wizard without having to reset
the device, by clicking Cancel . However, if you continue with the Wizard and start
loading the cmp file, the upgrade process must be completed with a device reset.
4. Click Browse, and then navigate to where the .cmp file is located on your computer.
Select the file, and then click Open.
5. Click Load File; the device begins to install the .cmp file. A progress bar displays the
status of the loading process and a message informs you when file load successfully
completes.
Figure 4-3: Software Upgrade Wizard – CMP File Loading Progress Bar
To Next Page
Loading...
