Audison bit one - Page 55

ADVANCED MANUAL / Bit One /
55
1. Connect the PC to the audio system where the DRC is installed
(Bit One or AC Link Interface for TH amplifiers) using a USB
cable.
2. Turn on the Bit One or the TH amplifier, so that the DRC is on.
3. Launch the software “DRC_upgrade_firmware_1.50.exe”.
4.
Wait for the PC to synchronize with the DRC
( scanning for devices).
5.
If the PC correctly synchronizes with the DRC,
click on “DRC Upgrade to V 1.50”.
6. A warning pop-up dialog box will appear, indicating that
you have to:
- close all running programs;
- disable screen saver;
- disable energy saving modes;
- disable anti-virus softwares.
Click “Yes”.
7. Wait until the upgrade procedure is completed.
12