2
Multi-turn actuators SA 07.1 – SA 16.1
with actuator controls AMB 01.1/AMB 02.1 Operation instructions
Scope of these instructions:
These operation instructions are valid for multi-turn actuators of the type
range SA 07.1 – SA 16.1 with controls AMB 01.1/AMB 02.1.
These operation instructions are only valid for ”clockwise closing”, i.e.
driven shaft turns clockwise to close the valve.
Table of Contents Page
1. Safety instructions 4
1.1 Range of application 4
1.2 Commissioning (electrical connection) 4
1.3 Maintenance 4
1.4 Warnings and notes 4
2. Short description 4
3. Technical data 5
4. Additional information to the wiring diagram legend 7
5. Transport and storage 7
6. Packaging 7
7. Mounting to valve/ gearbox 8
8. Manual operation 10
9. Electrical connection 11
9.1 Connection with AUMA plug/ socket connector 11
9.2 Heater 12
9.3 Motor protection 12
9.4 Remote position transmitter 12
9.5 Fitting of the cover 12
10. Opening the switch compartment 13
10.1 Removal of the switch compartment cover 13
10.2 Pulling off the indicator disc (option) 13
11. Setting of the limit switching 14
11.1 Setting for end position CLOSED (black section) 14
11.2 Setting for end position OPEN (white section) 14
11.3 Checking the switches 14
12. Setting of the DUO limit switching (option) 15
12.1 Setting for direction CLOSE (black section) 15
12.2 Setting for direction OPEN (white section) 15
13. Setting of the torque switching 16
13.1 Setting 16
13.2 Checking the switches for torque and DUO limit switching 16
14. Test run 17
14.1 Check direction of rotation 17
14.2 Check the setting of the limit switching 18
14.3 Check whether type of seating is set correctly 18
15. Setting of the potentiometer (option) 18
16. Setting of electronic position transmitter RWG (option) 19
16.1 Setting for 2-wire system 4 – 20 mA and 3- /4-wire system 0 – 20 mA 20
16.2 Setting for 3- / 4- wire system 4 – 20 mA 21
17. Setting of the mechanical position indicator (option) 22
18. Closing the switch compartment 22
To Next Page
Loading...
Need help?
General
