AUMA SAEx Series User Manual

355.2.4. Terminal compartment: close
365.3. External earth connection
375.4. Accessories for electrical connection
375.4.1. Actuator controls on wall bracket
385.4.2. Parking frame
396. Operation................................................................................................................................
396.1. Manual operation
396.1.1. Manual valve operation
406.2. Motor operation
406.2.1. Operating the actuator from local controls
416.2.2. Actuator operation from remote
416.3. Menu navigation via push buttons (for settings and indications)
426.3.1. Menu layout and navigation
436.4. User level, password
446.4.1. Password entry
446.4.2. Password change
456.5. Language in the display
456.5.1. Language change
477. Indications..............................................................................................................................
477.1. Indications during commissioning
477.2. Indications in the display
487.2.1. Feedback signals from actuator and valve
507.2.2. Status indications according to AUMA classification
517.2.3. Status indications according to NAMUR recommendation
537.3. Indication lights of local controls
547.4. Optional indications
547.4.1. Mechanical position indication (self-adjusting)
547.4.2. Mechanical position indication via indicator mark (not self-adjusting)
558. Signals (output signals).........................................................................................................
558.1. Signals via Profinet
558.2. Status signals via output contacts (digital outputs)
558.2.1. Assignment of outputs
558.2.2. Coding the outputs
558.3. Analogue signals (analogue outputs)
579. Commissioning (basic settings)...........................................................................................
579.1. Type of seating: set
589.2. Torque switching: set
609.3. Limit switching: set
629.4. Test run
629.4.1. Direction of rotation at mechanical position indicator: check
649.4.2. Direction of rotation at hollow shaft/stem: check
649.4.3. Limit switching: check
6610. Commissioning (settings/options in the actuator).............................................................
6610.1. Switch compartment: open/close
6710.2. Mechanical position indicator (self-adjusting)
6710.2.1. Mechanical position indicator: set
6810.2.2. Gear stage of the reduction gearing: test/set
6910.3. Mechanical position indication via indicator mark (not self-adjusting)
3
SAEx 07.2 – SAEx 16.2 / SAREx 07.2 – SAREx 16.2 Control unit: electronic (MWG)
ACExC 01.2 Non-Intrusive Profinet Table of contents

AUMA SAEx Series Specifications

General

Brand	AUMA
Model	SAEx Series
Category	Controller
Language	English