AUMA SAEx Series User Manual

Please state device type and our order number (see name plate) when ordering spare parts. Only original AUMA spare parts should be used.
Failure to use original spare parts voids the warranty and exempts AUMA from any liability. Representation of spare parts may slightly vary
from actual delivery.
TypeDesignationRef. no.
Sub-assemblyLocal controls002.0
Sub-assemblyLocal controls board002.3
Face plate for display002.4
Sub-assemblyPower supply unit006.0
I/O board008.1
Fieldbus board008.1
Sub-assemblyLogic board009.0
Sub-assemblyRelay board011.1
Option board012.0
Fieldbus connection board050.1
Sub-assemblyCover500.0
Pin carrier without pins502.0
Sub-assemblyPin for controls505.0
Sub-assemblyPin for motor506.0
Sub-assemblySwitchgear508.0
Sub-assemblyPadlock509.1
SetFuse kit510.0
Terminal frame (without terminals)528.0
Cable conduit (actuator connection)532.0
Retaining ring535.1
Ex plug/socket connector628.0
SetSeal kitS
96
SAEx 07.2 – SAEx 16.2 / SAREx 07.2 – SAREx 16.2 Control unit: electronic (MWG)
Spare parts ACExC 01.2 Non-Intrusive Profinet

AUMA SAEx Series Specifications

General

Explosion protection	ATEX, IECEx
Ingress protection	IP66 / IP68
Communication interfaces	Modbus, Foundation Fieldbus
Display	LCD
Control Signal	4-20 mA
Type of controller	Electric actuator controller