Owner Installation Instructions Axess Pro Series 3000 35
F - Transmitter Editing
Appendix
G - Transmitter Management
12 ID B B SMITH
OSC PED LGT VAC
Press Tx’er
Again View
Press Tx’er
Button! List
MENU 1
Code Transmitter
Transmitter Listing Facility
The Axess
®
Pro Series 3000 provides a transmitter listing facility
which enables the user to find a transmitter location within the
memory. Once located a stored transmitter can be replaced,
deleted, edited, copied or, if the location is empty, a new
transmitter can be coded.
Method 1 - Go To The Start Of The List
Accessing The List Menu
a. Press NEXT to navigate to Menu 1 (Fig. G.1).
b. Press SET to enter the transmitter edit procedure.
c. Press NEXT to enter the transmitter list and edit mode.
Method 2 - Use The Transmitter To Go Direct To The List
Accessing The List Menu
a. Press NEXT to navigate to Menu 1 (Fig. G.1).
b. Press SET to enter the transmitter edit procedure.
c. Press the transmitter once (Fig. G.2).
d. Press NEXT to view the transmitter parameters (Fig. G.3).
This method is used for quick navigation if the transmitter is
available.
NOTE: “VIEW” will not be shown if the transmitter is not stored.
Once the list is displayed, it can be sorted by stored number, ID
Label or Serial Number. Use the NEXT or PREV buttons to select
the sorting method.
NOTE: When sorting by ID label or S/N, only stored transmitters
locations are displayed.
Navigating The List
a. Press the OPEN or CLOSE buttons to navigate through the list
(Fig. G.4).
NOTE: Holding a button down will step through the list faster.
b. Press SET to display the menu of available functions.
Selecting An Operation
a. Press NEXT or PREV to cycle through the four menu options
(Fig G.5)
b. Press STOP to return to the list. Press SET to execute the menu’s
operation.
Fig G.1
Fig G.2
Fig G.3
Fig G.4
Menu Option Operation
Code Operation (location used) If the code operation is selected for a location that already contains a transmitter, then
the storing transmitter code procedure (Section 13.1) will be initiated and the new
transmitter will replace the existing one. Note the button functions and name of the
existing transmitter will be transferred to the new transmitter. This procedure is of great
convenience when replacing a lost transmitter.
Delete Operation The delete operation is used to remove a transmitter from memory along with the
name and button function settings.
Edit Operation The edit operation displays the transmitter record for editing purposes. See
TRANSMITTER EDIT PROCEDURE (Appendix B) for details.
Copy Operation The copy operation is used to code multiple transmitters with the same button function as
that of the selected transmitter. Once selected an abbreviated code set routine is initiated
which repeats steps 2 & 3 of the BASIC CODE TRANSMITTER PROCEDURE for each
transmitter to be coded. Coding is terminated by pressing the STOP button.
Exiting The List To exit the transmitter list, simply press STOP to return to the Code menu.
Fig G.5
To Next Page
Loading...
