Autonics Digipower 2000 User Manual

9.ModbusMappingTable
53
©CopyrightReservedAutonicsCo.,Ltd.
Address Item Factor
400031(001E) Operation
Bit0...
Bit1...
Bit2...
Bit3...
Bit4...
Bit5...
Bit6...
Bit7...
Bit8...
Bit9...
Bit10...
Bit11...
Bit12...
Bit13...
Fault
I-OC
Over current
Over volt
Over temperature
Fuse cut
Phase loss
Load open
Over SCR
Over Frequency
Run/Stop
Auto/Manual
EMS Power
Not Load
400032(001F) Output slope (%) *0.001(0 to 1.000)
400033(0020) Output (%) for input 0% *0.01(0 to 1000)
400034(0021) Input correction *0.1(-999 to 999)
400035(0022) Input slope correction *0.1(-999 to 999)
400036(0023) Overcurrent alarm output 0 to 2 (*1)
400038(0025) Overvoltage alarm output
0 to 2
400039(0026) Burn out fuse alarm
400041(0028)
Heat sink temperature abnormal
condition alarm
400042(0029) Element error alarm
400044(002B) Heater break alarm

Autonics Digipower 2000 Specifications

General

Brand	Autonics
Model	Digipower 2000
Category	Controller
Language	English