Need help?Do you have a question about the Autonics DPU Series and is the answer not in the manual?
General| Communication | RS-485 (Modbus RTU) |
|---|---|
| Mounting | Panel mount |
| Input Type | Thermocouple, RTD, Voltage, Current |
| Control Output | Relay, Current |
| Power Supply | 100-240VAC, 24VDC |
| Control Method | PID control, ON/OFF control |
| Operating Temperature | 0°C to 50°C (32°F to 122°F) |
| Storage Temperature | -20°C to 60°C (-4°F to 140°F) |
Defines categories for safety warnings and cautions to prevent accidents and hazards.
Highlights the main features of the DPU Series power controllers, including speed, accuracy, and controls.
Lists all technical specifications including electrical, environmental, and physical properties.
Diagrams showing terminal connections for single-phase DPU1 Series models by size.
Details the function of each terminal for input signals, control, and communication.
Illustrates terminal connections for 3-phase DPU3 Series models by size.
Schematic of input signals, control inputs, and power connections for the unit.
Covers parameters for operation mode, including soft start, limits, slope, and constants.
Details parameters for Setting Mode 1, such as control input, method, and digital inputs.
Covers alarm settings and delay times within Setting Mode 2.
Describes various control methods: Normal, Constant Voltage, Constant Current, Constant Power.
Explains functions assigned to digital inputs: AUTO/MAN, RUN/STOP, and SP settings.
Lists and describes various alarms: Overcurrent, Overvoltage, Fuse, Heatsink, Element, Heater.
Configures overcurrent alarm thresholds, delay times, and current limiting parameters.
Details settings for overvoltage, fuse disconnection, and heatsink overheating alarms.
Covers settings for element error alarms and heater disconnection detection.
Details the Modbus request and response structure for reading holding registers.
To Next Page
