Autonics DPU Series - Table of Contents

Table of Contents
vii
© Copyright Reserved Autonics Co., Ltd.
-|Transparent setting guide|-
Table of Contents
Preface
....................................................................................................... iii
User Manual Guide
...............................................................................iv
User Manual Symbols
...........................................................................v
Safety Considerations
......................................................................... vi
Table of Contents
.................................................................................vii
Table of Contents
................................................................................viii
1. Product Introduction
...................................................................... 11
1.1 Features
..................................................................................................................11
1.2 Ordering information
.......................................................................................12
1.3 Unit description
..................................................................................................13
2. Specications
...................................................................................15
4. Connections
.......................................................................................22
4.1 Single-phase (DPU1 series)
..........................................................................22
4.2 3-phase (DPU3 series)
.....................................................................................24
5. Installation and Initial Operation
............................................... 26
5.1 Installation
.............................................................................................................26
5.2 Initial display
........................................................................................................26
5.3 Parameter setting group
................................................................................26
5.3.1 Parameters.................................................................................................26
5.3.2 Monitoring Mode .......................................................................................27
5.3.3 Operation Mode [
OP
] .................................................................................28
5.3.4 Setting Mode 1 [
ST-1
] ..............................................................................29
5.3.5 Setting Mode 2 [
ST-2
] ..............................................................................30
6. Parameter Setting and Functions
.............................................32
6.1 Control input
........................................................................................................32
6.2 Functions
...............................................................................................................33
6.2.1 Control method [
C-MD
] .............................................................................33
6.2.2 Soft start [
ST-T
] ........................................................................................36
6.2.3 Start limit [
S-LM
] and start limit time [
S-LT
] .........................................37
6.2.4 Output slope setting [
SLOP
] .....................................................................37
6.2.5 Output slope manual adjustment [
A-GA
] ................................................38
6.2.6 Base-up [
B-UP
] .........................................................................................38