Autonics DPU Series User Manual

5. Installation and Initial Operation
27
© Copyright Reserved Autonics Co., Ltd.
-|Transparent setting guide|-
5.3.2 Monitoring Mode
IN 10)0
LD-V 22)0
LD-A 5)0
KW 1)00
RES 50
FREQ 6)00
P
P
P
P
P
P
RUN
mode
※
1.
P
: Press any key among , .
※
To return RUN mode, press the
key at any parameter, or not to operate any keys
in 30 sec.
For ON/OFF input, or SSR pulse input, it displays 0 or 100.
• Setting range: Within 0.0 to 100.0%
Monitors measured voltage at load within the rated voltage range.
Monitors measured current at load within the rated current range.
Monitors measured power at load within the rated power range.
Displays measured resistance at load for initial set resistance as percentage
Displays frequency of power
Input value
Load voltage
Load current
Load power
Load
resistance
Power
frequency
V
V
A
A
※
1
1 sec
(1) Single-phase (DPU1 series)
(2) 3-phase (DPU3 series)
)00
)0
)0
)0
)0
)0
)0
For ON/OFF input, or SSR pulse input, it displays 0 or 100.
• Setting range: Within 0.0 to 100.0%
Monitors measured voltage at load within the rated voltage range.
Monitors measured current at load within the rated current range.
Monitors load power output at 3-phase.
Displays LLLL, 10 to 500%, HHHH.
Displays frequency of power within 45.0 to 65.0Hz range
IN )0
U-V
V-W
W-U
LA-U
LA-V
LA-W
KW
RES )0
FREQ )00
P
P
P
P
P
P
P
P
P
P
Input value
Voltage between
U-V line
Voltage between
V-W line
Voltage between
W-U line
U-phase
load current
V-phase load
current
W-phase
load current
Load power
Load resistance
Power frequency
※
1
RUN
mode
※
1.
P
: Press any key among , .
※
To return RUN mode, press the
key at any parameter, or not to operate any keys
in 30 sec.
1 sec
V
V
V
A
A
A
V
A

Autonics DPU Series Specifications

General

Brand	Autonics
Model	DPU Series
Category	Controller
Language	English