Autonics DPU Series - Table of Contents

Table of Contents
viii
© Copyright Reserved Autonics Co., Ltd.
-|Transparent setting guide|-
6.2.7 Slow up/Slow down [
UP-T
/
DN-T
] ..........................................................39
6.2.8 Output high limit value [
H-OL
], Output low limit value [
L-OL
] .............39
6.2.9 Digital input (DI) ........................................................................................40
6.2.10 Proportional and integral constant set of feedback control .................42
6.2.11 Input correction[
IN-B
] .............................................................................43
6.2.12 Input slope correction [
SPAN
] ..................................................................43
6.2.13 Display value content [
DISP
], bar graph content [
BAR
] ........................43
6.2.14 Load resistance display method [
DRES
] .................................................44
6.2.15 Full load auto recognition [
F-LD
] ............................................................45
6.2.16 Parameter lock [
LOCK
] ..............................................................................45
6.3 Alarm
........................................................................................................................46
6.3.1 Overcurrent alarm [
OC-A
].........................................................................46
6.3.2 Current limit [
C-LM
] ..................................................................................46
6.3.3 Overvoltage alarm [
OV-A
] ........................................................................47
6.3.4 Fuse disconnection alarm [
FUSE
] ...........................................................47
6.3.5 Heatsink overheating alarm [
HEAT
] .........................................................47
6.3.6 Element error alarm [
SCR
] ........................................................................47
6.3.7 Heater disconnection alarm [
HB-A
] ........................................................48
7. Factory Default
.................................................................................50
8. Maintenance
.......................................................................................52
8.1 Fuse
..........................................................................................................................52
8.1.1 Single-phase (DPU1 series) .....................................................................52
8.1.2 3-phase (DPU3 series) ..............................................................................53
8.2 Thyristor (SCR)
...................................................................................................53
9. Modbus Mapping Table
.................................................................54
9.1 Function code 3 (0×03) = Read holding resisters
..............................54
9.2 Function code 4 (0×04) = Read input resisters
...................................54
9.3 Function code 6 (0×06) = Write single resisters
.................................55
9.4 Function code 16 (0×10) = Write multiple resisters
..........................55
9.5 Address mapping table
...................................................................................56
9.5.1 Input resisters ...........................................................................................56
9.5.2 Holding resisters .......................................................................................58
Table of Contents