Autonics DPU Series User Manual

Safety Considerations
vi
© Copyright Reserved Autonics Co., Ltd.
-|Transparent setting guide|-
Safety Considerations
● Following these safety considerations will ensure the safe and proper use of the product and help
prevent accidents and minimize hazards.
● Safety considerations are categorized as Warnings and Cautions, as dened below:
● Fail-safe device must be installed when using the unit with machinery that may cause serious
injury or substantial economic loss. (e.g. nuclear power control, medical equipment, ships,
vehicles, railways, aircraft, combustion apparatus, safety equipment, crime/disaster prevention
devices, etc.)
Failure to follow this instruction may result in personal injury, economic loss or re.
● Do not use the unit in the place where ammable/explosive/corrosive gas, high humidity, direct
sunlight, radiant heat, vibration, impact, or salinity may be present.
Failure to follow this instruction may result in explosion or re.
● Install on a device panel, and ground separately.
Failure to follow this instruction may result in re or electric shock.
● Do not connect, repair, or inspect the unit while connected to a power source.
Failure to follow this instruction may result in re or electric shock.
● Do not disassemble or modify the unit.
Failure to follow this instruction may result in re or electric shock.
● Check ‘Connections’ before wiring.
Failure to follow this instruction may result in re.
● Use the unit within the rated specications.
Failure to follow this instruction may result in re or product damage.
● Use a dry cloth to clean the unit, and do not use water or organic solvent.
Failure to follow this instruction may result in re or electric shock.
● Keep the product away from metal chip, dust, and wire residue which ow into the unit.
Failure to follow this instruction may result in re or product damage.
● Since leakage current still ows right after turning o󰀨 the power or in the output OFF status, do
not touch the load terminal.
Failure to follow this instruction may result in electric shock.
● Since leakage current still ows right after turning o󰀨 the power or in the output OFF status, do
not touch the load terminal.
Failure to follow this instruction may result in electric shock.
The specications, dimensions, etc are subject to change without notice.
Be sure to follow cautions written in the instruction manual, user manual and the technical descrip-
tions (catalog, homepage).
Warning
Cases that may cause serious injury or fatal accident if
instructions are not followed.
Caution
Cases that may cause minor injury or product damage
if instructions are not followed.

Autonics DPU Series Specifications

General

Brand	Autonics
Model	DPU Series
Category	Controller
Language	English