Autonics DPU Series User Manual

7. Factory Default
50
© Copyright Reserved Autonics Co., Ltd.
-|Transparent setting guide|-
7. Factory Default
(1) Operation mode
Parameter Default Parameter Default
ST-T 0000 C-LM 11)0
S-LM 11)0 SP1 00)0
S-LT 0000 SP2 00)0
A-GA OFF SP3 00)0
SLOP !000 SP4 00)0
B-UP 00)0 SP5 00)0
UP-T 0003 SP6 00)0
DN-T 0003 P 0150
L-OL 00)0 I 02)0
H-OL 11)0
(2) Setting mode 1
Parameter Default Parameter Default
IN-P 4-20
BAR
Single-
phase
LD-V
C-MD PA
3-phase
U-V
DI-1 SP M DRES DOWN
DI-2 SP1 F-LD OFF
DI-3 SP1 ADDR 0001
IN-B 00)0 BAUD 384
SPAN 00)0 COMW ENA
DISP
Single-
phase
LD-V LOCK OFF
3-phase
U-V
(3) Setting mode 2
Parameter Default Parameter Default
OC-V 11)0 FUSE AL1
OC-T 0005 HEAT AL1
OC-A AL1 SCR AL1
OV-V 11)0 HB-V 01)0
OV-T 0005 HB-A AL2
OV-A AL1 HB-T
Single-
phase
30

Autonics DPU Series Specifications

General

Brand	Autonics
Model	DPU Series
Category	Controller
Language	English