7 User Screen
© Copyright Reserved Autonics Co., Ltd. 143
7.5 Device connection status display
If configurated connect device is not connected or connection has error, at [SYSTEM SETTING]
- [Environment] - [Serial Communication] menu displays error message as following screen.
Touch ‘CLOSE’ and error message dialog box disappears. If connection error is not resolved
after 5 seconds, error message appears again on the screen.
Connection error message appers only on user screen.
When the third (CH1), fourth (CH2) bit of system signal 1 device in system information device
are ON status, error message for specified connect device appears on the screen.
For further details, refer to ‘GP Editor user manual’.
To Next Page
Loading...